CLASS
A 5W - TUBE REVERB - 12" Speaker - 6V6/6L6 Compatible
SPACE
TONE REVERB |
Specifications
- 5W CLASS
A ~ BIG Monster fuzz tone at max!
- Single-Ended
Output - Zero Negative Feedback
- 100% Tube
Circuit - GZ34 Rectifier (Can sub NOS 5Y3)
- Big, Lush
Swart Tube Reverb - Foot Switchable
- Powered
by choice of 6V6 ~ 6L6 Family
- JJ 12AX7(2)
- JJ 12DW7 - EH 6V6GT - JJ GZ34 Rectifier
- Point to
Point Hand Wired Circuit
- Cathode Biased
(no need to bias)
- Carbon Comp
Resistors ~ Mallory Caps
- Cloth Hook-Up
Wire
- Hi/Lo Input
for High & Low powered Pickups
- Heaters referenced
to ground
- Standby
Switch for tube warm-up, extending tube life
- All Swart
Amplifiers employ Star Grounding
- 4/8 ohm 1/4"
Out - Drive other Speaker/Cabinet
- Switchcraft
1/4 inch inputs and output
- CTS Potentiometers
- Custom High
Quality USA Built Heyboer Iron
- Speaker:
12" Mojotone BV-30H ~ 8 ohm
- Finger-Jointed,
solid Pine Cab w/ Retro Tolex
- Vintage
Jewel Lamp ~ Circuit Fuse Protected
- Dimensions:
15 7/8 T x
16 3/8W x 9 1/4 D ~ 28lbs
|
- Click above for full resolution -
|
- Click
above full high resolution - |
Hi/Lo Inputs
~ Volume / Tone / Reverb ~ Power/Standby
- Click above for lower back view - |
|
Fuse
Info
Amps with IEC
socket have a backup short fuse above IEC plug to sub; IF rectifier
arcs, or there is a power issue, this is the first fuse to check
and usually the fix. Use small screwdriver to pry open plate to
reveal fuse and backup fuse if not been used already. The long "power
tube protection" fuse is located between rectifier and power
tube. Remember, if the fuse DID blow, it's best to give the amp,
especially the rectifier and power tubes, a good look.
-
STR (2 Fuses)............................IEC
2 Amp ~ Slow-Blow | 200ma Long Fuse (Power Tube)
|
 |
|
©2007-2016 swart
amplifier co. 2031 wrightsville
ave wilmington nc 910.620.2512 info@swartamps.com
design & hosting by 
|
